CNC Machined Parts — Turn-Mill & Multi-Axis Precision Components
Contact for quote
Rods, bolts and inserts are turned from C36000 or H62 bar and threaded on the same machine, so the thread runs concentric with the shank instead of being cut in a second operation and drifting off centre. M2 to M12 metric threads, lengths of 5 to 100 mm. The free-cutting grades give a clean thread flank and a chip that breaks short, which is what keeps the pitch diameter consistent across a 500-piece run. Typical use: terminal blocks and earth studs in electrical assemblies, fittings in sanitary ware, and threaded inserts in plastic housings.
Hex heads, slots and cross holes are milled in the same plant, so a fastener that needs a hex, a slot and a drilled cross hole arrives as one part instead of three. When the head shape is non-standard, send the drawing: the flats are cut to the width across corners you specify, and the edges are deburred before plating.
Hex head bolts
One thread size in five lengths, turned and threaded in a single setup.
Pointed screws
Hex head with a pointed tip for driving into wood or a pre-tapped plastic boss.
Threaded inserts and nuts
Slotted and plain inserts with matching hex nuts, supplied as one set.
Washers and nuts
Flat washers and hex nuts from M2 up, finished the same way as the rod.
Parts ship either bare brass or nickel plated. Bare brass keeps the machined look and stays conductive, which is what electrical terminals usually need; the nickel layer gives a harder, brighter surface for parts that are handled or seen. Plating runs on racks, and parts are rinsed and dried before packing so no solution stays in the thread roots.
Above a few thousand pieces the parts run through a vibratory bowl that orients and counts them, which keeps the piece count exact and takes out the hand-sorting step that usually adds a day to a brass order. Minimum order is 500 pieces, and lead time is 7 to 12 days from drawing or sample approval.
Parts are bagged in fixed counts by size, then packed into compartmented cartons so one thread size is never mixed with another. Each carton is labelled with the thread callout, length and finish. If the bags have to be marked for a line-side station, say so on the order and the labels are printed that way.
Thread callout, length, head style and the material you want, C36000 for free cutting or H62 for the higher copper content, are enough to quote. Add the drawing if the head or the shank is non-standard. For plated parts, say whether the thread has to stay conductive after plating. That decides whether the part is plated all over or the contact area is left bare.
Fill out the form below and we will get back to you as soon as possible.